Installation Instructions
Table Of Contents
- Foreword
- Installation Requirements for Compliance with Radio Frequency (RF) Energy Exposure Safety Standards
- Table of Contents
- Mobile Radio Model Numbering Scheme
- Commercial Warranty
- Chapter 1 Introduction
- Chapter 2 Standard Configurations
- 2.1 Planning the Installation
- 2.2 Radio Mounting
- 2.2.1 Dash Mount with Trunnion
- 2.2.2 Remote Mount with Trunnion
- 2.2.2.1 Transceiver
- 2.2.2.2 Control Head and Remote Mount Cabling
- 2.2.3 Locking Kit (Optional)
- 2.3 Power Cable
- 2.4 Ignition Sense Cable
- 2.5 Antenna Installation
- 2.6 Speaker
- 2.7 Microphone Hang-Up Clip
- 2.8 Completing the Installation
- Chapter 3 Options and Accessories Installation
- Chapter 4 Motorcycle Radio Installation
- 4.1 Motorcycle Radio Description
- 4.2 Installation Overview
- 4.3 Installing the Universal Mounting Plate
- 4.4 Installing the Speaker and Control Head
- 4.4.1 Handlebar Installation with Speaker and Control Head Mounted Together
- 4.4.2 Fuel Tank Console Installation with Speaker and Control Head Mounted Together
- 4.4.3 Handlebar Installation with Speaker and Control Head Mounted Separately
- 4.4.4 Fuel Tank Console Installation with Speaker and Control Head Mounted Separately
- 4.5 Installing the Speaker
- 4.6 Installing the Microphone Hang-Up Clip
- 4.7 Installing Cables
- 4.8 Installing the Weather-Resistant Enclosure
- 4.9 Transceiver and Cabling Installation
- 4.10 Installing the Antenna
- 4.11 Installing the Emergency Switch Option
- 4.12 Installing the External Alarm Relay Option
- 4.13 Installing the Headset Accessory
- 4.14 Horn/Lights Wiring
- 4.15 Emergency Switch Wiring
- Chapter 5 Finishing the Installation: Cable Connection
- Appendix A Replacement Parts Ordering
- Glossary
- Index
September 30, 2004 6881098C38-O
2-12 Standard Configurations: Radio Mounting
Figure 2-19. 100W Radio Mounting into Screw-Mounted Trunnion
2.2.2.2 Control Head and Remote Mount Cabling
For radios equipped with optional remote mount control heads, see
Figure 2-8 or Figure 2-9. For
radios equipped with remote handheld control heads, see Figure 2-11 or Figure 2-12. Choose a
mounting location for the radio, considering accessibility, and control and antenna cable lengths.
2.2.2.2.1 Remote W4, W5, W7, and W9 Model Control Head Installation
Figure 2-20 shows each of the control head models.
If you are required to insert any of the replaceable buttons available with these radios, refer to the
XTL 5000 Basic Service Manual (Motorola publication part number 6881096C73) for further
information.
Figure 2-20. W4, W5, W7, and W9 Control Heads
W4
W7
W9
W7
W9
W5
W5