User's Manual
Table Of Contents
- CDM1250 Mobile Radio Professional Radio User Guide
- Contents
- Computer Software Copyrights
- Safety
- Radio Overview
- Getting Started
- Radio Calls
- Making a Selective Call
- Receiving a Selective Call F
- Sending a Call Alert™ Page
- Receiving a Call Alert Page
- Radio Check
- responding to emergency alerts E
- Clearing an Emergency Alert E
- Sending an Emergency Remote Monitor
- Sending an Emergency Alert E
- Selective Radio Inhibit
- Repeater or Talkaround J Mode
- Setting the Power Level B
- Name and Call Tone Tagging
- Scan
- Phone
- Audio/Tone Settings
- Utilities
- Warranty
- Accessories
Sending a Call
1. Turn radio on and select appropriate zone and channel.
2. Press
PTT
, hold the microphone 1 to 2 inches (2.5 to 5 cm) from your mouth,
and speak clearly into it.
3. Release
PTT
to listen.
Receiving a Call
1. Turn radio on and adjust volume to the desired level.
2. Select desired channel.
3. To respond to an incoming call, press
PTT
, hold the microphone 1 to 2 inches
(2.5 to 5 cm) from your mouth, and speak clearly into it.
Deleting a Nuisance Channel During Scanning
1. While radio is on a nuisance channel, hold down preprogrammed
Scan
button
until you hear a tone.
2. Release
Scan
button.
Making a Phone Call
1. Press
Phone
button, or select
Phone
from the menu.
2. If access code is not displayed, send access code if required.
3. Send phone number in one of the following ways:
• Press and release
PTT
to send last dialed number.
—or—
• when using enhanced keypad microphone only, press preprogrammed
Speed Dial
button, followed by a keypad key (1–8), to access first nine num-
bers in your phone list. (Press
PTT
if buffered dial.)
—or—
• when using enhanced keypad microphone only, enter phone number using
the keypad. (Press
PTT
if buffered dial.)
4. Press
PTT
, hold the microphone 1 to 2 inches (2.5 to 5 cm) from your mouth,
and speak clearly into it.
Ending a Phone Call
1. Send deaccess code if required.
2. Press preprogrammed
Phone
button, or press the
Exit
key.
Sending and Cancelling an Emergency Alert
• To activate Emergency Alert, press preprogrammed
Emergency
button or
footswitch.
• To cancel, press and hold down
Emergency
button.
CDM1250
™
Quick Reference Card
Record the functions for your radio’s programmable buttons in the table
provided below. For further information, see page 6 of this User Guide.
MAEPF 26782 O
(Interchangeable)
Programmable
Button 2 (P2)
(Interchangeable)
Programmable
Button 4 (P4)
(Interchangeable)
Programmable
Button 3 (P3)
LCD Screen
Red/Yellow/Green
LED Indicators
(Up/Down)
(Interchangeable)
Programmable
Button 1 (P1)
Channel Selector
Microphone
Jack
Knob
On/Off/Volume
Button Function Short Press Long Press Hold Down Page