User's Manual
Table Of Contents
- CDM1250 Mobile Radio Professional Radio User Guide
- Contents
- Computer Software Copyrights
- Safety
- Radio Overview
- Getting Started
- Radio Calls
- Making a Selective Call
- Receiving a Selective Call F
- Sending a Call Alert™ Page
- Receiving a Call Alert Page
- Radio Check
- responding to emergency alerts E
- Clearing an Emergency Alert E
- Sending an Emergency Remote Monitor
- Sending an Emergency Alert E
- Selective Radio Inhibit
- Repeater or Talkaround J Mode
- Setting the Power Level B
- Name and Call Tone Tagging
- Scan
- Phone
- Audio/Tone Settings
- Utilities
- Warranty
- Accessories
26
English
RADIO CALLS
NAME AND CALL TONE TAGGING
You can program your radio to sound a
particular alert tone when:
• a specific user is calling—name tone
tagging, or
• your radio is receiving a type of radio call—
call tone tagging.
There are seven alert tones to select from.
Note: The enhanced keypad microphone is
required to operate this feature.
To tag a specific user’s name or ID:
The display shows the current power level.
6 y or z until
or until
7 Press the Menu/Enter button to confirm the
selection.
1 Press the Menu/Enter button to
enter Menu
Mode.
Power High?
Power Low?
2 y or z until
3 Press the Menu/Enter
button to select
4 y or z until
5 Press the Menu/Enter
button to select
6 y or z until you see the name or call you
want to tag.
7 Press the Menu/Enter button to confirm the
selection.
8 y or z until you hear one of the seven
tones you want to use for this name or call.
9 Press the Menu/Enter button to confirm the
selection.
You will see
10 Press the Exit button
to return to
–or–
Hold down the Exit button to exit Menu Mode.
Audio/Tones
Audio/Tones
Name Tone Tag
Name Tone Tag
Name Tag Set
Name Tone Tag