User's Manual
Table Of Contents
- CDM1250 Mobile Radio Professional Radio User Guide
- Contents
- Computer Software Copyrights
- Safety
- Radio Overview
- Getting Started
- Radio Calls
- Making a Selective Call
- Receiving a Selective Call F
- Sending a Call Alertâ„¢ Page
- Receiving a Call Alert Page
- Radio Check
- responding to emergency alerts E
- Clearing an Emergency Alert E
- Sending an Emergency Remote Monitor
- Sending an Emergency Alert E
- Selective Radio Inhibit
- Repeater or Talkaround J Mode
- Setting the Power Level B
- Name and Call Tone Tagging
- Scan
- Phone
- Audio/Tone Settings
- Utilities
- Warranty
- Accessories
12
English
GETTING STARTED
SELECTING A ZONE
A zone is a group of up to 16 channels. Before
you can access a channel in a zone, you must
select the zone in one of two ways:
Method 1 (if programmed by your dealer [see
pages 6 - 7])
Method 2 (enhanced keypad microphone
required)
SELECTING A RADIO CHANNEL
Your radio offers 64 channels (4 zones of 16
channels each).
Note: Due to government regulations, some
channels may not be programmed.
See your dealer for more information.
There are three ways to select a channel:
Method 1
Method 2 (if programmed by your dealer [see
pages 6 - 7])
Press the Home Revert button.
1 Press the Direct Zone Access button.
2 y or z until you reach the desired zone.
3 Press the Direct Zone Access button to
select the zone.
1 Press the Menu/Enter button to enter Menu
Mode.
2
y or z until
3 Press the Menu/
Enter button to select
Zone
Zone
4
y or z until you see the desired zone
name.
5 Press the Menu/Enter button to select the
zone.
1 Select the appropriate Zone, if required.
2 y or z until you reach the desired
channel, shown on the LCD display.