User's Manual

6881096C72-A August 7, 2003
Standard Configurations: Radio Mounting 2-5
Figure 2-11. Trunnion Orientation
2.2.1 Dash Mount with Trunnion
1. Select the location to mount your radio on the transmission hump (see
Figure 2-12) or under
the dash (see Figure 2-13). When mounting the trunnion on the transmission hump take care
the transmission housing is not affected.
2. Using the trunnion mounting bracket as a template, mark the positions of the holes on the
mounting surface. Use the innermost four holes for a curved mounting surface such as the
transmission hump, and the four outmost holes for a flat surface such as under the dash.
3. Center punch the spots you have marked and realign the trunnion in position.
4. Secure the trunnion mounting bracket with the four self-drilling screws provided (see
Figure 2-12 and Figure 2-13).
5. Ensure that the plastic guides are aligned (horizontal) to the grooves of the trunnion. Slide the
radio into the grooves until it snaps into place (see
Figure 2-12). Secure the radio with the two
wing screws provided.
Figure 2-12. Transmission Hump Trunnion Mounting
RADIO
FRONT
APPLIES TO RADIOS WITH INTEGRAL
OR REMOTE MOUNT CONTROL UNITS
Tabs
Trunnion
Groove
Wing Screw
Wing Screw
Plastic Guides
Threaded Hole
for Wing Screw