User's Manual
Table Of Contents
- Foreword
- Table of Contents
- Mobile Radio Model Numbering Scheme
- Commercial Warranty
- Chapter 1 Introduction
- Chapter 2 Standard Configurations
- 2.1 Planning the Installation
- 2.2 Radio Mounting
- 2.2.1 Dash Mount with Trunnion
- 2.2.2 Remote Mount with Trunnion
- 2.2.2.1 Transceiver
- 2.2.2.2 Control Head and Remote Mount Cabling
- 2.2.3 Locking Kit (Optional)
- 2.3 Power Cable
- 2.4 Ignition Cable
- 2.5 Antenna
- 2.6 Speaker
- 2.7 Microphone Hang-Up Clip
- 2.8 Completing the Installation
- Chapter 3 Options and Accessories Installation
- Chapter 4 Motorcycle Radio Installation
- 4.1 Motorcycle Radio Description
- 4.2 Installation Overview
- 4.3 Installing the Universal Mounting Plate
- 4.4 Installing the Speaker and Control Head
- 4.4.1 Handlebar Installation with Speaker and Control Head Mounted Together
- 4.4.2 Fuel Tank Console Installation with Speaker and Control Head Mounted Together
- 4.4.3 Handlebar Installation with Speaker and Control Head Mounted Separately
- 4.4.4 Fuel Tank Console Installation with Speaker and Control Head Mounted Separately
- 4.5 Installing the Speaker
- 4.6 Installing the Microphone Hang-Up Clip
- 4.7 Installing Cables
- 4.8 Installing the Weather-Resistant Enclosure
- 4.9 Transceiver and Cabling Installation
- 4.10 Installing the Antenna
- 4.11 Installing the Emergency Switch Option
- 4.12 Installing the External Alarm Relay Option
- 4.13 Installing the Headset Accessory
- 4.14 Horn/Lights Wiring
- 4.15 Emergency Switch Wiring
- Chapter 5 Finishing the Installation: Cable Connection
- Appendix A Replacement Parts Ordering
- Glossary
- Index
August 7, 2003 6881096C72-A
2-4 Standard Configurations: Radio Mounting
Figure 2-10. Radio Installation (Remote) Using W3 Control Heads
2.2 Radio Mounting
The mounting location must be accessible and visible. Select a location that will permit routing the
RF antenna cable as directly as possible.
NOTE: For optimum radio performance, orient the mounting trunnion as shown in
Figure 2-11. For
new or existing installations, use only the XTL 5000 trunnion (kit number: HLN6861_).
CAUTION: DO NOT mount the radio on a plastic dashboard
without first reinforcing the dashboard; the weight of the radio may
crack or break the dashboard.
CAUTION: DO NOT mount the radio on a flat or concave surface
where the radio could be partially submersed in water. This is
especially important if the cab area of the vehicle is cleaned by
spraying with water. If the radio sits in water for a length of time,
moisture may seep inside the radio and damage the electronic
components.
CAUTION: DO NOT allow water to stand in recessed areas of
vertically mounted radios. Remove any moisture immediately to
prevent it from seeping down into the radio.
BATTERY
LIGHT OR
HORN
RELAY
SPEAKER
EMERGENCY
SWITCH
FUSE
BLOCK
(+)
(-)
REMOTE
MOUNT CONTROL
CABLE
MAEPF-27615-O
FIREWALL
HOLE
ANTENNA
CONNECTION
DC POWER
CABLE
RADIO
J3
REMOTE MOUNT
ACCESSORY CONNECTOR
DIG
GND
SPKR
LO
SPKR
HI
IGNITION
SWB+
VIP
OUT 2
EMER
NOTE 1
NC
BUS+
NC
NOTE 2
BUSY
VIP OUT 1 BUS-
NOTES:
1. TX AUDIO IN SP CUSTOMER APPLICATIONS.
2. DET AUDIO IN SP CUSTOMER APPLICATIONS.
12345
6
7
8
15 14 13
12 11 10 9
HANDHELD
CONTROL
HEAD
HANG-UP
BOX
IGNITION CABLE
J3
PINOUT
FUSE
FUSE
J5
P506
J6
!
C a u t i o n