User's Manual
Table Of Contents
- Contents
- Introduction
- Basic Operating Procedures
- General Radio Features
- Often-Used Features
- Emergency Call and Alarm
- Scan Operation
- Turning On Scan
- Turning Scan On While Disregarding the Squelch Code (Conventional Modes Only)
- Viewing a Scan List
- Transmitting While Scan Is On
- Temporarily Deleting a Nuisance Mode with Scan On (W7 and W9 Control Heads Only)
- Restoring a Nuisance Mode (W7 and W9 Control Heads Only)
- Changing Mode Priorities While Scan Is On (W7 and W9 Control Heads Only)
- Restoring Mode Priorities in a Scan List (W7 and W9 Control Heads Only)
- Programming a Scan List
- Hang Up Box (HUB)
- Optional External Alarms (Horn and Lights)
- Time-Out Timer
- Push-To-Talk Identification (PTT-ID)
- Telephone Interconnect List (Conventional and Trunking)
- Unlimited Telephone Interconnect (W7 and W9 Control Heads Only)
- Call Alert Page (Conventional and Trunking— Digital Modes Only)
- Conventional Radio Features
- Trunking Operation
- Secure Operation
- Troubleshooting
- Glossary
- Index
- W7 and W9 Control Heads Foldout Page
78
Trunking Operation
Storing a Unit ID Number in the
Private Conversation List
(W7 and W9 Control Heads Only)
The Private Conversation and Call Alert page features share the
same prestored list of unit IDs.
1 Press and hold to review the list.
The Page indicator flashes and a valid-key chirp sounds.
2 Press the Mode rocker switch to locate the list member you
want to change.
3 Press to select the unit ID store function.
4 Enter the new unit ID number on the keypad.
Note: If you make an error, press the Mode down
rocker switch
or to erase each incorrect digit.
5 Press to store the new ID.
6 Repeat steps 2 through 5 until all the desired IDs have been
entered.
OR
Do one of the following:
• Press to return to normal radio operation.
OR
• Press to return to normal Call Alert operation.
Page
Sel
#Del
Sel
HOME
Page