Service Manual

52
Remove the Top Cover 1. Insert a wide flat-blade screwdriver or like instrument in the
recess area on the side of the main chassis near the RF connector
end (see Figure 26).
2. Pry the cover off the chassis by pushing the handle of the
screwdriver in and toward the chassis. This will disengage the
snap between the cover and chassis.
3. Repeat Step 1 and Step 2 for the opposite side of the radio.
Remove the Interface
Board
1. Remove the antenna connector retaining clip by inserting a small
flat-blade screwdriver or like instrument between the clip and the
top of the cavity wall as shown in Figure 27. Gently pry upwards.
2. Remove the board screws with a T-10 Torx Driver.
3. Carefully remove the interface board by rotating it out of the
chassis. Slowly lift the board on the front edge while pushing up
on the board through the accessory connector opening. Pull the
board forward out of the chassis (see Figure 28).
Figure 25. Removing the Front Housing
Depress Snap Here
See Detail "A"
Front Housing
Main Chassis
Detail "A"
Figure 26. Removing the Top Cover
Disengage Snap
here and on
other side
See Detail A
Disengage
Snap here
Detail “A”