Service Manual

15
5. Press PTT Toggle again to key up the radio at the selected
frequency point.
6. Repeat steps 3-5 for (F2-F7).
7. Press Program to store the softpot values into the radio’s
codeplug.
8. Exit the Transmit High Power function. The mobile will reset
upon exiting
If low power channels are used, perform Transmit Low Power Tuning
as shown in Table 3.
To perform Transmit Low Power Tuning, do the following:
1. Under the Tx Align menu, select Transmit Power, then select
Low.
2. Press PTT Toggle. This will key the radio up at F1.
3. Adjust the power level by moving the slider/spin control or
keying in values in the edit control (press ENTER to confirm
selection after typing in the softpot value).
Figure 14. Transmit High Power Window in the Global Tuner
Table 3. Transmit Low Power Level for VRS750s
RF Band (MHz) Low Power (mW)
VHF (136-174) 240-310
UHF Band 1 (403-470) 240-310
UHF Band 2 (450-527) 240-310