User's Manual
Table Of Contents
- Introduction
- Product Description
- Technology and Benefits
- Applications
- Configuration Options – RF, IP, DFS
- Power and Grounding
- Administration Systems
- Specifications
- Radio specifications (common to all formats)
- Specifications for PMP 430 (5.4 & 5.8-GHz) SM and PTP 230 (5.4 & 5.8-GHz) BH radio with integrated antenna
- Specifications for PMP 400 (4.9 & 5.4-GHz) AP/SM and PTP 200 (4.9 & 5.4-GHz) BH radio with integrated antenna
- Specification for PMP 400/430 AP and PTP 200 BH connectorized radio
- Specifications for PMP 400/430 kitted, connectorized radio (antenna included)
- Performance
- Planning
- Configuring
- Installation
- Regulatory and Legal Notices
- Important Note on Modifications
- National and Regional Regulatory Notices
- U.S. Federal Communication Commission (FCC) Notification
- Industry Canada (IC) Notification
- Regulatory Requirements for CEPT Member States (www.cept.org)
- European Union Notification for 5.8 GHz Product
- Equipment Disposal
- EU Declaration of Conformity for RoHS Compliance
- UK Notification
- Luxembourg Notification
- Czech Republic Notification
- Greece Notification
- Brazil Notification
- Labeling and Disclosure Table for China
- Exposure Separation Distances
- Legal Notices
- Limit of Liability
PMP 400/430 and PTP 200/230 Series Motorola PMP Solutions User Guide Supplement
Issue 6.0 May 2011 Page 5 of 77
Figure 26: DFS Status on AP "Home => DFS Status" page. ......................................... 46
Figure 27: Region Code on AP “Configuration => General” page .................................. 50
Figure 28: Configured Region Code on SM Configuration => General page ................. 51
Figure 29: Active Region Code on SM Home => General Status page .......................... 51
Figure 30: Ground lug highlighted on AP ....................................................................... 61
Figure 31: Dielectric Grease – Apply to RJ45 connector ............................................... 62
Figure 32: Dielectric Grease - Insert Ethernet Cable ..................................................... 63
List of Procedures
Procedure 1: Assembling a 5.8 or 5.4 GHz AP, and attaching to tower ......................... 56
Procedure 2: Assembling a 4.9 GHz AP, and attaching to tower ................................... 58
Procedure 3: Cabling and Grounding/Earthing the AP ................................................... 61