User's Manual
Table Of Contents
- Introduction
- Product Description
- Technology and Benefits
- Applications
- Configuration Options – RF, IP, DFS
- Power and Grounding
- Administration Systems
- Specifications
- Radio specifications (common to all formats)
- Specifications for PMP 430 (5.4 & 5.8-GHz) SM and PTP 230 (5.4 & 5.8-GHz) BH radio with integrated antenna
- Specifications for PMP 400 (4.9 & 5.4-GHz) AP/SM and PTP 200 (4.9 & 5.4-GHz) BH radio with integrated antenna
- Specification for PMP 400/430 AP and PTP 200 BH connectorized radio
- Specifications for PMP 400/430 kitted, connectorized radio (antenna included)
- Performance
- Planning
- Configuring
- Installation
- Regulatory and Legal Notices
- Important Note on Modifications
- National and Regional Regulatory Notices
- U.S. Federal Communication Commission (FCC) Notification
- Industry Canada (IC) Notification
- Regulatory Requirements for CEPT Member States (www.cept.org)
- European Union Notification for 5.8 GHz Product
- Equipment Disposal
- EU Declaration of Conformity for RoHS Compliance
- UK Notification
- Luxembourg Notification
- Czech Republic Notification
- Greece Notification
- Brazil Notification
- Labeling and Disclosure Table for China
- Exposure Separation Distances
- Legal Notices
- Limit of Liability
PMP 400/430 and PTP 200/230 Series Motorola PMP Solutions User Guide Supplement
Issue 6.0 May 2011 Page 51 of 77
Figure 29: Configured Region Code on SM Configuration => General page
Figure 30: Active Region Code on SM Home => General Status page
The AP or BHM always operates under its manually configured Region Code (the one on the
Configuration => General page), and so does not show a Region Code on its Home => General
Status page.
Under normal operations, APs and BHMs operating with DFS (see
Table 14) will experience an
additional minute after power-up or reboot before they will register any SMs or BHSs. SMs and
BHSs operating with DFS (see
Table 14) will experience an additional minute after they reboot
before they will register to an AP or BHM.
It takes two reboots to set the parameters described below on a module starting from factory
defaults. Set the Region Code as described above, Save Changes, and Reboot. If the module