User's Manual

PMP 400/430 and PTP 200/230 Series Motorola PMP Solutions User Guide Supplement
Issue 6.0 May 2011 Page 50 of 77
Figure 28: Region Code on AP “Configuration => General” page
An SM/BHS has both a configurable Region Code and, once it registers to an AP or BHM, an
active Regional Code. After an SM/BHS registers to an AP/BHM, it uses the region code of the
AP/BHM to determine its DFS behavior and displays the AP/BHM’s region code on its Home =>
General Status page, as shown in
Figure 30.
The two Region Codes on an SM/BHS should be the same in normal operation. However, they
will not be the same if, for example, an SM configured with a Region Code of “None” has
registered to an AP with a Region Code of Europe as shown in
Figure 29 and Figure 30.