User's Manual

PMP 400/430 and PTP 200/230 Series Motorola PMP Solutions User Guide Supplement
Issue 6.0 May 2011 Page 17 of 77
4940APC
4.9 GHz OFDM Connectorized
AP – No antenna
DES
Requires CMM4
w/56 VDC supply
2.6.4
4941APC
4.9 GHz OFDM Connectorized
AP – No antenna
AES
Requires CMM4
w/56 VDC supply
2.6.4
PTP 49200
Model
Number
4.9 GHz OFDM Backhaul (BH)
Description
Encryption
Picture
Power 56 VDC
CMM Type
Specs
in
Section
4940BH
4.9 GHz OFDM BH
DES
Wall type 56VDC
supply or CMM4
w/56 VDC supply
2.6.3
4941BH
4.9 GHz OFDM BH
AES
Wall type 56VDC
supply or CMM4
w/56 VDC supply
2.6.3
4940BHC
4.9 GHz OFDM Connectorized
BH – No antenna
DES
Wall type 56VDC
supply or CMM4
w/56 VDC supply
2.6.4
4941BHC
4.9 GHz OFDM Connectorized
BH – No antenna
AES
Wall type 56VDC
supply or CMM4
w/56 VDC supply
2.6.4
A Cluster Management Module (CMM4) provides GPS synchronization and power to the PMP
400/430 and PTP 200/230 series of products:
Table 6 details the power requirements of the APs
and BHs.
Table 6: CMM4 56VDC and 30 VDC Operation
Frequency
PMP Series
Access Point (AP)
PTP 230 Series
Backhaul (BH)
Canopy Custom
Power over Ethernet (PoE)
5.8 GHz
5.4 GHz
PMP 430 Series –
CAP 58430/54430
PTP 230 Series –
PTP 58230/54230
56 VDC - Power on pins 5 &
8, return on pins 4 & 7
5.4 GHz
PMP 400 Series –
CAP 54400
PTP 200 Series –
PTP 54200
30 VDC - power on pins 7
and 8 and return on pins 4
and 5
4.9 GHz
PMP 400 Series –
CAP 49400
PTP 200 Series –
PTP 49200
56 VDC - Power on pins 5 &
8, return on pins 4 & 7
The CMM4 can be configured with either or both a 56VDC and a 30VDC external power supply
as shown in
Figure 10 and Figure 11. The CMM4 must be used for 56 VDC operations which are
required for the PMP 430 5.4 and 5.8-GHz AP, PMP 400 4.9-GHz AP, PTP 200 4.9-GHz BH, and
PTP 230 5.4 and 5.8-GHz BH. The CMMmicro only supports 30 VDC operations.