User's Manual

PMP320HDW2v1 5-15
Pr
e
limin
a
r
y
J
UL
2
0
1
0
PMP 320 Hardware Installation Installing the 600SSD Surge Suppressor
Installing the 600SSD Surge Suppressor
■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■
■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■
■ ■ ■ ■ ■ ■ ■ ■ ■ ■
■
■
Use the following procedure to install the 600S SD Surge suppressor .
CAUT I ON
Observe caution when drilling through the wall of the building. Ensure that there are
no power lines, gas lines, water lines, or data lines in the wall at the desired location
where the drilling takes place.
Procedure 5-9 Installing the 600SSD Surge Suppressor
1
W ith the cable openings facing downward, install the 600S SD surge
suppressor above the site where the hole in the residence has been drilled.
Use two screws to attach the unit following regulatory building guidelines.
2
Connect the surge suppressor to Earth Ground. Refer to Connecting the
CSM to the Ethernet cable, Earth Ground, the Surge Suppressor on page
6- 13 . Refer to Figure 6-7 .
3
P ack both of the 600S SD surge suppressor Ethernet jacks with dielectric
grease.
4
Include a splicing loop in the Ethernet cable from the CSM (extra cable to
allow future repositioning or reconnectorization) and position and secure the
Ethernet
cable with UV -resistant wire ties or other locally-approved fasteners
so it forms a drip loop (so water drips off the cable instead of following the
cable into the 600S SD surge suppressor).
5
Connect the Ethernet connection from the CSM to the surge suppressor .
6
Build another Ethernet cable to span from the surge suppressor through
the residence wall to the area where the power injector will be placed in
the subscriber’s residence.
7
Guide the Ethernet cable through the grommet where the drilled hole was
made
into the residence.
8
Seal the cable entry point into the building using accepted industry or local
practices.
9
Connect the Ethernet cable to the Data In port of the CSM power injector .
Refer to Figure 6-8 .