User's Manual

PMP320HDW2v1 3-27
Preliminary
JUL
2010
Installation Overview Chapter 3: CMM4 Hardware Installation
Installation Overview
■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■
■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■
■ ■ ■ ■ ■ ■ ■ ■ ■ ■
■
■
Before beginning the physical installation of the CMM4 hardware make sure the GUI
configuration is completed. Refer to configuration details in the PMP 320 Administration and
Configuration Guide for additional information on the GUI configuration procedures.
The physical installation of the CMM4 includes the following:
• physically install the CMM on the tower (or near the communications hut)
• physically install the GPS unit (included with the CMM4, does not have to be ordered
separately)\
• physically install the surge suppressors
• cable the following CMM4 components:
GPS
P ower
ENET
600S SD surge suppressor
200SB surge suppressor
L - COM surge suppressor (if the Gigabit Ethernet port is in use at this site, the L - COM
must be installed inside the CMM4 unit, or inside the communication’s hut, this
item is never installed out doors)
Earth to ground