User's Manual

JUL
2010
Preliminary
AP Hardware Installation complete Chapter 3: CMM4 Hardware Installation
Figure 3-1 AP Installation and wiring
AP
Communications B l dg
Cable Tray
BT-0781S-XXX
BT-0781S-XXX
AP Grounded
to
Tower
with 10AWG wire
Network
Switch or
Router
CMM4
Drip Loop
600SSD
AC Power
SGPN4076
200SSB
Tower Ground
Earth Ground
Tower
NOTE
• The L - COM surge suppressor is used if the Gigabit Ethernet port is used in
the CMM4. The L - COM when used is installed either in the CMM4 cabinet, or
installed inside the communications building.
• This figure shows the GPS near the top of the AP unit. F or installation
information
about the GPS refer to Installing the GPS Antenna on page 3 - 7 .
• The AC line cord is not provided with the hardware.
3-2 PMP320HDW2v1