User's Manual

PMP320HDW2v1 2-17
Pr
e
limin
a
r
y
J
UL
2
0
1
0
PMP 320 Hardware Installation Attach the AP assembly to a pole
NOTE
• The L - COM surge suppressor is used if the Gigabit Ethernet port is used in
the CMM4. The L - COM when used is installed either in the CMM4 cabinet, or
installed inside the communications building.
• This figure shows the GPS near the top of the AP unit. F or installation
information
about the GPS refer to Installing the GPS Antenna on page 3 - 7 .
• The AC line cord is not provided with the hardware.
This figure shows the GPS near the top of the AP unit. F or installation information about the
GPS refer to Installing the GPS Antenna on page 3 - 7 .
Procedure 2-3 Attaching the AP assembly to a pole
1
Using standard work and safety practices for tower climbing, connect the
assembled unit (assembled antenna, brackets and radio) to a pole, mounting
fixture, or a tower . The unit must be mounted to avoid accidental touching
by personnel. The standard mounting height is typically at least 4 m (13
ft) above ground level.
Pole Is Shown
For Reference
Antenna
Radio
(Secured on Antenna)
DIV connector
MAIN connector
Ethernet
NOTE
Approximate cable distance between the AP and the CMM4 is 100
meters.
Continued