User's Guide

Your radio can support up to 250 scan lists, with a
maximum of 16 members in a list.
Each scan list supports a mixture of both analog and digital
entries.
7.7
Scan
Your radio cycles through the programmed scan list for the
current channel looking for voice activity when you start a
scan.
There are two ways of initiating scan:
Main Channel Scan (Manual)
Your radio scans all the channels or groups in your
scan list. On entering scan, your radio may, depending
on the settings, automatically start on the last scanned
active channel or group, or on the channel where scan
was initiated.
Auto Scan (Automatic)
Your radio automatically starts scanning when you
select a channel or group that has Auto Scan enabled.
7.7.1
Turning Scan On or Off
Follow the procedure to turn scan on or off on your radio.
Do one of the following:
• Press the programmed Scan button to start or
stop Scan.
• Turn the Channel Selector Knob to select a
channel programmed with a scan list.
If scan is enabled:
• The yellow LED blinks.
• A positive indicator tone sounds.
If scan is disabled:
• The LED turns off.
• A negative indicator tone sounds.
7.7.2
Responding to Transmissions During
Scanning
During scanning, your radio stops on a channel or group
where activity is detected. The radio stays on that channel
English
50