User's Guide

26.2
Scan Talkback
The Talkback feature allows you to respond to a transmission while scanning.
Depending on how you configure the Scan Talkback feature, you will see two different scenarios if you
press the PTT button when your radio scans into a call from the selectable group scan list.
Table 24: Scan Talkback Type
Type Description
Scan Talkback Disabled During an ongoing scanned call, if the PTT but-
ton is pressed, the scanned call is terminated
and a new call is launched.
Scan Talkback Enabled During an ongoing scanned call, if the PTT but-
ton is pressed, you can talkback to the scanned
call.
NOTE:
If you face the following scenarios:
1 Scan into a call for a group that is not assigned to a channel position in the currently
selected zone
2 Miss the Hang Time of the call.
Perform the following actions:
1 Switch to the proper zone.
2 Select the channel position of the group to talk back to that group.
26.3
Nuisance Channels
Nuisance Channel is a channel that generates unwanted call continually.
You can temporarily remove the unwanted channel from the scan list and restore it back later on. This
capability does not apply to the channel designated as the Selected Channel.
26.3.1
Deleting Nuisance Channels
Prerequisites:
Your radio is scanned into the Nuisance Channel.
Procedure:
1 Press the programmed Nuisance Delete button until you hear a tone.
2 Release the programmed Nuisance Delete button.
26.3.2
Restoring a Nuisance Channel
Procedure:
Perform one of the following actions:
• Restart your radio.
MN006217A01-AF
Chapter
26 : Scan
101