User's Guide

English
100
NOTE:
During the cloning process, no power is being
applied to the SUC. The batteries are not
charged. Only data communication is being
established between the two radios.
4 Turn on the Target Radio and place it into one of the
SUCs.
Figure 17: Radio to Radio Cloning
1 Turn the radio off.
2 Unplug any cables from the SUC.
3 Plug one side of the cloning cable mini USB
connector to the first SUC, and the other end to the
second SUC.
5 To turn on the Source Radio, press PTT→Volume
Down buttons at the same time for three seconds.
You hear Cloning Mode beeps, and "Cloning Mode,
Serial" voice prompt from your radio.
6 For the Source Radio, power on the radio with the
following sequence:
1 Press PTT→Volume Down buttons at the same
time while turning the radio on. Wait three
seconds before releasing the buttons, and you
hear “Clone Mode Serial” voice prompt from your
radio.