User's Guide

4.6.7.1
Viewing Detected Beacons
Prerequisites: Turn on Indoor Location. If Indoor Location is turned off, the screen displays Service
Restricted.
Procedure:
1 From the home screen, press the Menu key.
2 Select Bluetooth→Indoor Location.
3 Select Beacons Found.
4 Select the preferred beacon.
The screen displays details of the beacon.
4.6.8
Connecting Firearms Devices
Prerequisites: Only pre-approved firearms devices can be used. The service provider is responsible
for configuring the radio to work with specific devices. See Add Bluetooth Devices on page 153.
When and where to use: To select a firearm sensor device for Bluetooth connection.
Procedure:
1 From the home screen, press the Menu key.
2 Select Bluetooth→Firearms.
3 Highlight your firearm sensor device and press Connect.
NOTE:
Activation code must be sent to the device by third-party application.
Radio-initiated automatic reconnection with several remote Bluetooth devices at the
same time cannot be guaranteed to be successful in 100%, due to the fundamental
nature of Bluetooth. In case the reconnection fails after a power cycle (power off and
power on of the radio), reconnect the device manually.
The radio is now able to notify the dispatcher when the status of the firearm device changes. If
configured, the location (using GNSS) of the radio is reported as well. Once a firearm sensor
device is connected, it can be managed from the Devices menu.
4 To disconnect a firearm sensor device, go to the Devices menu and follow the normal device
management procedure.
4.7
Browser
This menu item activates a WAP browser that allows you to browse the Internet from your radio. See
Wireless Application Protocol (WAP) on page 168.
MN006260A01-AD
Chapter 4 : Main Menu
108