User's Guide

2 Press the PTT button to respond to the call.
The LED lights up solid green.
3 Wait for the Talk Permit Tone to finish (if enabled),
and speak clearly into the microphone.
4 Release the PTT button to listen.
If there is no voice activity for a predetermined period of
time, the call ends.
You hear a short tone.
See Making a Private Call on page
100 for details on
making a Private Call.
6.2.5.3
Receiving a Site All Call
A Site All Call is a call from an individual radio to every
radio on the site. It is used to make important
announcements requiring the user's full attention.
When you receive an Site All Call, a tone sounds and the
LED blinks green.
Your radio unmutes and the incoming call sounds through
the radio speaker.
A Site All Call does not wait for a predetermined period of
time before ending.
You cannot respond to a Site All Call.
NOTICE:
The radio stops receiving the Site All Call if you
switch to a different channel while receiving the call.
During a Site All Call, you will not be able to use any
programmed button functions until the call ends.
6.2.5.4
Receiving an Inbound Private Phone
Call
When you receive an Inbound Private Phone Call, the LED
blinks green. The radio unmutes and the incoming private
phone call sounds through the radio's speaker.
1 Press and hold the PTT
button to answer and talk.
Release the PTT button to listen.
2 Press preprogrammed Phone Exit button to end the
call.
A short feedback tone sounds.
English
98