User's Guide

Table Of Contents

Wait for 15 minutes and then repeat the steps in

Accessing the Radio by Using Password on page

81 to

access the radio.

5.7.22

Over-the-Air Programming

Your dealer can remotely update your radio by using Over-

the-Air Programming (OTAP) without physical connection.

Additionally, some settings can also be configured by using

OTAP.

When your radio undergoes OTAP, the green LED blinks.

When your radio receives high volume data:

• The channel becomes busy.

• A negative tone sounds if you press the PTT button.

NOTICE:

Once the programming is complete, a tone sounds,

and your radio restarts (powers off and on again).

5.7.23

Wi-Fi Operation

This feature allows you to set up and connect to a Wi-Fi

network. Wi-Fi supports updates for radio firmware,

codeplug, and resources such as language packs and

voice announcement.

NOTICE:

This feature is applicable to XPR 7350e/XPR 7380e

only.

Wi-Fi

is a registered trademark of Wi-Fi Alliance

Your radio supports WEP/WPA/WPA2-Personal and WPA/

WPA2-Enterprise Wi-Fi networks.

WEP/WPA/WPA2-Personal Wi-Fi network

Uses pre-shared key (password) based authentication.

Pre-shared key can be entered by using the menu or

CPS/RM.

WPA/WPA2-Enterprise Wi-Fi network

Uses certificate-based authentication.

Your radio must be pre-configured with a certificate.

NOTICE:

Check with your dealer or system administrator

to connect to WPA/WPA2-Enterprise Wi-Fi

network.

The programmed Wi-Fi On or Off button is assigned by

default. Check with your dealer or system administrator to

determine how your radio has been programmed.

English