User's Guide

The radio exits the Emergency Alarm mode.
NOTICE:
When configured for Emergency Alarm only, the
emergency process consists only of the Emergency
Alarm delivery. The emergency ends when an
acknowledgment is received from the system, or
when channel access attempts have been
exhausted.
No voice call is associated with the sending of an
Emergency Alarm when operating as Emergency
Alarm Only.
5.7.15.2
Sending Emergency Alarms with Call
This feature allows you to send an Emergency Alarm with
Call to a group of radios or a dispatcher. Upon
acknowledgment by the infrastructure within the group, a
group of radios can communicate over a programmed
Emergency channel.
The radio must be configured for Emergency Alarm and
Call to perform an emergency call after the alarm process.
1 Press the programmed Emergency On button.
The green LED lights up.
NOTICE:
If your radio is programmed, the Emergency
Search tone sounds. This tone is muted
when the radio transmits or receives voice,
and stops when the radio exits Emergency
mode.
If an Emergency Alarm acknowledgment is
successfully received:
• The Emergency tone sounds.
•
The green LED blinks.
If an Emergency Alarm acknowledgment is not
successfully received:
• All retries are exhausted.
• A low-pitched tone sounds.
• The radio exits the Emergency Alarm mode.
2 Press the PTT button to initiate a voice transmission.
The green LED lights up.
English
74