User's Guide

Table Of Contents
Replace the dust cover when the universal connector is not
in use.
2.8
Turning the Radio On
Rotate the On/Off/Volume Control knob clockwise
until it clicks.
If successful, your radio shows the following indications:
A tone sounds.
NOTICE:
If the Tones/Alerts function is disabled, there is
no tone upon powering up.
The green LED lights up.
NOTICE:
During the initial power-up after a software version
update to R02.07.00.0000 or later, a GNSS
firmware upgrade takes place for 20 seconds. After
the upgrade, the radio resets and turns on. This
firmware upgrade is only applicable for portable
models with the latest software and hardware.
If your radio does not power up, check your battery. Make
sure that the battery is charged and properly attached.
Contact your dealer if your radio still does not power up.
2.9
Turning the Radio Off
Rotate the On/Off/Volume Control knob
counterclockwise until it clicks.
2.10
Adjusting the Volume
To adjust the volume of your radio, perform one of
the following actions:
To increase the volume, turn the
On/Off/Volume
Control knob clockwise.
To decrease the volume, turn the On/Off/Volume
Control knob counterclockwise.
English
34