User's Guide

Press the orange Emergency button.
Once the Emergency Alert is successfully sent and is being
broadcast for other radios to hear, a positive indicator tone
sounds.
6.3.10.6
Exiting Emergency Mode
NOTICE:
If the Emergency call ends due to the expiration of
the Emergency Hang Time, but the emergency
condition is not over, press the Emergency button
again to restart the process.
If you initiate an Emergency Alert by pressing the
programmed Emergency button, your radio automatically
exits Emergency mode after receiving a response from the
Connect Plus system.
If you initiate an Emergency call by pressing the
programmed Emergency button, your radio will be
assigned a channel automatically when one becomes
available. Once your radio has transmitted a message
indicating the emergency, you cannot cancel your
Emergency call. However, if you pressed the button by
accident or the emergency no longer exists, you may wish
to say this over the assigned channel. When you release
the PTT button, the Emergency call is discontinued after
the Emergency Call Hang Time expires.
If your radio was configured for Emergency with Voice to
Follow, use the “hot mic” period to explain your error, then
press and release the PTT
button to discontinue the
transmission. The Emergency call is discontinued after the
Emergency Call Hang Time expires.
6.3.11
Man Down Alarms
NOTICE:
This feature is applicable to XPR 7350e/XPR 7380e
only.
Man Down Alarms are not supported when
operating in Fallback mode. For more information
see the
Auto Fallback on page 103.
This section describes the Connect Plus Man Down
Feature. This is a purchasable feature that may or may not
apply to your radio.
Your Connect Plus portable radio can be enabled and
programmed for one or more of the Man Down Alarms.
Your dealer or radio system administrator can tell you
English
116