User's Guide

possible that none of the transmissions will be
understood by receiving radios.
Making calls in Fallback mode is similar to normal
functioning. Simply select the group contact you wish to
use (using the radio’s normal channel selection method),
and then press the PTT to start your call. It is possible that
the channel may be in use already by another group. If the
channel is in use, you receive a busy tone. You may select
Group, Multi-group or Site All Call contacts using your
radio’s normal channel selection method. While the radio is
operating on the Fallback Channel, the Multigroup operates
just like other Groups. It is only heard by radios that are
currently selected to the same Multi-group.
6.3.2.3
Returning to Normal Operation
If the site returns to normal trunking operation while you are
in range of your Fallback repeater, your radio automatically
exits Auto Fallback mode. You hear a registration "beep"
when the radio successfully registers. If you are in the
range of an operable site (that is not in Fallback mode), you
may press the Roam Request button (if programmed for
your radio) to force your radio to search for and register on
an available site. If no other site is available, your radio
returns to Auto Fallback mode after searching is complete.
If you drive out of coverage of your Fallback repeater, your
radio enters Search mode.
6.3.3
Scan
This feature allows your radio to monitor and join calls for
groups defined in a pre-programmed scan list. When scan
is enabled, the LED blinks yellow when idle.
6.3.3.1
Starting and Stopping Scan
NOTICE:
This procedure turns the Scan feature On or Off for
all Connect Plus zones with the same Network ID as
your currently selected zone.
You can start and stop scanning by pressing the
programmed Scan button.
• A tone sounds indicating that Scan has been turned on
or off.
•
When Scan is enabled, the tone’s pitch increases.
• When Scan is disabled, the tone’s pitch decreases.
English
105