User's Guide

Remote Monitor
This feature is used to turn on the microphone of a target
radio with a subscriber alias or ID. You can use this feature
to remotely monitor any audible activity surrounding the
target radio.
Both your radio and the target radio must be programmed
to allow you to use this feature.
This feature stops after a programmed duration or when
there is any user operation on the target radio.
Initiating Remote Monitor
Follow the procedure to initiate Remote Monitor on your
radio.
1 Press the programmed Remote Monitor button.
2 Wait for acknowledgment.
If successful:
A positive indicator tone sounds.
If unsuccessful:
A negative indicator tone sounds.
Scan Lists
Scan lists are created and assigned to individual channels
or groups. Your radio scans for voice activity by cycling
through the channel or group sequence specified in the
scan list for the current channel or group.
Your radio can support up to 250 scan lists, with a
maximum of 16 members in a list.
Each scan list supports a mixture of both analog and digital
entries.
Scan
Your radio cycles through the programmed scan list for the
current channel looking for voice activity when you start a
scan.
There are two ways of initiating scan:
Main Channel Scan (Manual)
Your radio scans all the channels or groups in your
scan list. On entering scan, your radio may, depending
on the settings, automatically start on the last scanned
active channel or group, or on the channel where scan
was initiated.
English
47