User's Guide

For high degree of reliability, Motorola Solutions recommends to NOT separate the radio and the
accessory.
At the fringe areas of reception, both voice and tone quality will start to sound "garbled" or "broken". To
correct this problem, simply position the accessory and radio closer to each other (within the 10 meter
defined range) to re-establish clear audio reception.
NOTICE: Once a COTS headset is paired to your radio, it is always connected. Therefore the
battery life of the accessory is aligned with the Talk Time power consumption, not the Standby
Time consumption.
Procedure:
Turn on the accessory. Then, place it close to the radio aligning the Bluetooth Pairing Location
(a blue dot) on the radio to the Bluetooth Pairing Location (a blue dot) on the accessory.
If the pairing process is successful, you hear an incremental-pitched tone. The radio begins to
connect to the device.
If the pairing process fails, you hear a short, low-pitched tone. The display shows PAIRFAIL.
Repeat this step.
The radio tries to establish connection with the device once paired.
NOTICE: If the connection fails within 6 seconds, you hear a decremental-pitched tone to
indicate that the device is unpaired. The display shows <Device Type> UNPAIRED. Repeat
this step to re-initiate the pairing process.
If the connection is successful, you hear an incremental-pitched tone. The display shows <Device
Type> CONNCTED and the Bluetooth icon turns from
to .
If the radio has the pairing record of the device and the connection fails, you hear a short, low-pitched
tone. The display shows <Device Type> CON FAIL.
6.14.4
Standard Pairing Feature
The Bluetooth Standard Pairing feature enables your Bluetooth enabled radio to search for other
Bluetooth enabled and discoverable devices.
NOTICE: Bluetooth tones, Bluetooth menu, and preprogrammed buttons must be
preprogrammed by a qualified radio technician. Check with your dealer or system administrator
for more information.
Once the device is discovered, your radio automatically pairs with the device.
6.14.4.1
Searching and Pairing the Bluetooth Device
Prerequisites: Ensure the Bluetooth on your device is turned on and is set to Discoverable in order
to enable your radio to detect your device in Bluetooth.
When and where to use: Bluetooth Search in Bluetooth Standard Pairing method is used to scan for
other Bluetooth devices nearby. It is set to turn off by default.
MN006727A01-AA
Advanced Features
63