User's Guide
Table Of Contents
- Contents
- List of Tables
- Software Version
- Read Me First
- Preparing Your Radio for Use
- Radio Controls
- Status Indicators
- General Radio Operation
- Advanced Features
- 6.1 Advanced Call Features
- 6.2 Scan Lists
- 6.3 Scan
- 6.4 Call Alert Paging
- 6.5 Emergency Operation
- 6.5.1 Special Considerations for Emergency Operation
- 6.5.2 Emergency Keep-Alive
- 6.5.3 Exiting Emergency Operation
- 6.5.4 Exiting Emergency as Supervisor (Trunking Only)
- 6.5.5 Sending an Emergency Alarm
- 6.5.6 Sending an Emergency Call (Trunking Only)
- 6.5.7 Sending An Emergency Call With Hot Mic (Trunking Only)
- 6.5.8 Sending an Emergency Alarm with Emergency Call
- 6.5.9 Sending An Emergency Alarm and Call with Hot Mic
- 6.5.10 Sending a Silent Emergency Alarm
- 6.5.11 Emergency Find Me
- 6.6 Fireground
- 6.7 Tactical Public Safety (Conventional Only)
- 6.8 Man Down
- 6.9 Secure Operations
- 6.10 Radio Inhibit
- 6.11 Global Positioning System/Global Navigation Satellite System
- 6.12 Mission Critical Geofence (ASTRO 25 Trunking)
- 6.13 Trunking System Controls
- 6.14 Mission Critical Wireless Bluetooth®
- 6.14.1 Turning On Bluetooth
- 6.14.2 Turning Off the Bluetooth
- 6.14.3 Pairing with Low Frequency-Motorola Proximity Pairing (LF-MPP) Feature
- 6.14.4 Standard Pairing Feature
- 6.14.5 Turning On the Bluetooth Audio
- 6.14.6 Turning Off the Bluetooth Audio
- 6.14.7 Adjusting the Volume of the Radio from Bluetooth Audio Device
- 6.14.8 Clearing All Bluetooth Devices Information
- 6.14.9 Pairing with LEX Handheld
- 6.14.10 Responder Alert Sensors
- 6.15 ASTRO 25 (P25) Programming Over Project 25 (POP25)
- 6.16 Voice Announcement
- 6.17 Site Selectable Alerts (ASTRO 25 Trunking)
- 6.18 Wi-Fi
- 6.19 Utilities
- 6.19.1 Using the Flip Display
- 6.19.2 Selecting a Basic Zone Bank
- 6.19.3 Selecting the Power Level
- 6.19.4 Controlling the Display Backlight
- 6.19.5 Locking and Unlocking the Controls
- 6.19.6 Turning Voice Mute On or Off
- 6.19.7 Using the Time-Out Timer
- 6.19.8 Conventional Squelch Operation
- 6.19.9 Using the PL Defeat Feature
- 6.19.10 Digital PTT ID Support
- 6.19.11 Smart PTT (Conventional Only)
- 6.19.12 Transmit Inhibit
- 6.19.13 Instant Recall
- Accessories
- Legal and Compliance Statement
- Maritime Radio Use in the VHF Frequency Range
- Limited Warranty
- Glossary
- ACK
- Active Channel
- Analog Signal
- ARS
- ASTRO 25
- ASTRO conventional
- Autoscan
- Bluetooth
- Bluetooth Pairing
- Call Alert
- Carrier Squelch
- Central Controller
- Channel
- Control Channel
- Conventional
- Conventional Scan List
- COTS
- Cursor
- Digital Private Line (DPL)
- Digital Signal
- Dispatcher
- Digital Signal Processor
- Dynamic Regrouping
- Failsoft
- FCC
- Hang up
- IV&D
- Key Variable Loader
- Liquid-Crystal Display (LCD)
- Light Emitting Diode (LED)
- Li-Ion
- Man Down
- MCW
- MDC
- Monitor
- Multi-System Talkgroup Scan List
- Network Access Code
- NiMH
- Non-tactical/revert
- OCW
- Over-The-Air Rekeying
- Page
- Personality
- Preprogrammed
- Private (Conversation) Call
- Private Line (PL)
- Programmable
- Push-to-Talk
- Radio Frequency
- Repeater
- selective switch
- Squelch
- Synchronous Serial Interface (SSI)
- Standby
- Status Calls
- Tactical/non-revert
- TalkAround
- Talkgroup
- Trunking
- Trunking Priority Monitor scan list
- USK
- VRS
- Zone
NOTICE: Because Man Down may be triggered accidentally, consider the following scenarios
when using your radio:
• If the radio is programmed to a horizontal position only, it must be worn in a vertical position.
• If the radio is programmed with the Man Down feature, turn off the radio when charging it
with a wall-mounted charger.
6.8.1
Radio Alerts When Man Down is Triggered
When Man Down is triggered, your radio plays an alert tone and the display shows MAN-DOWN.
NOTICE: If the radio is programmed for Surveillance Mode, it inhibits all tones and lights
including the Man Down tones.
Man Down Enhanced
Your radio also supports Man Down Enhanced where it plays an alert tone for a preprogrammed
period. This tone is louder than the preprogrammed minimum level or the current level of the speaker
and it acts as a beacon that helps to find the radio.
NOTICE: The radio plays this alert tone even in Surveillance Mode.
When the alert tone is active, changing to another channel with a different setup triggers a different
response from the radio:
• The alert tone is inhibited when you change to a channel without Emergency feature.
• The alert tone is inhibited when you change to a channel with Emergency but no Man Down
feature.
• The current alert tone is inhibited and is replaced with a different alert tone when you change to a
channel with Emergency feature and a different Man Down configuration.
• The alert tone continues when you change to a channel with Emergency and similar Man Down
configuration.
6.8.2
Testing the Man Down Feature
Prerequisites: Ensure that Man Down is configured on your radio.
Procedure:
1 Turn on the radio and place it in a vertical position for at least five seconds.
2 Lay the radio down in a horizontal position.
The radio plays an alert tone and the display shows MAN-DOWN.
Postrequisites: If Man Down is configured but the condition does not trigger the activation of the
feature, send the radio to a qualified technician.
6.8.3
Exiting Man Down
Procedure:
To exit Man Down mode, press Clr.
MN006727A01-AA
Advanced Features
53