User's Guide

If... Then...
If you change to a channel/mode with Emergen-
cy capability while in Emergency operation,
the Emergency Alarm and/or Emergency Call
continues on the new channel/mode.
If the radio is out-of-range of the system or the
emergency alarm is not acknowledged,
a tone sounds and the display shows No ac-
knowledge.
6.5.2
Emergency Keep-Alive
This feature prevents the radio from being turned off when it is in Emergency mode. If this feature is
enabled, you are required to exit Emergency mode before turning off your radio.
6.5.3
Exiting Emergency Operation
If an Emergency operation is triggered on your radio, the dispatch console or radios configured as
Supervisor can also exit the Emergency operation.
Procedure:
To exit Emergency operation, press and hold the preprogrammed Emergency button.
6.5.4
Exiting Emergency as Supervisor (Trunking Only)
Radios configured as Supervisor are able to cancel emergency mode of other radios. The dispatch
console must be preprogrammed to use this feature. Check with your dealer or system administrator
for more information on dispatch console supporting this feature.
Procedure:
1 Perform one of the following actions:
If… Then…
If the emergency mode is ini-
tiated by other radios,
press and hold the Side Button 1 and press the Emer-
gency button.
If the emergency mode is ini-
tiated by the Supervisor,
Perform one of the following actions:
• Press and hold the Emergency button.
• Press and hold the Side Button 1 and press the
Emergency button.
• Wait for console to clear emergency.
NOTICE: The following buttons combinations are supported:
• Radio Side Button 1 and Top (Orange) button.
• Radio Side Button 1 and accessory Orange button.
• Accessory 1-Dot Button and radio Top (Orange) button.
• Accessory 1-Dot Button and accessory Orange button.
MN006727A01-AA
Advanced Features
46