User's Guide

3 To remove the antenna, turn the antenna counterclockwise.
NOTICE: When removing the antenna, ensure that the radio is turned off.
2.4
Removing and Attaching the Accessory Connector Cover
When and where to use: The accessory connector is on the antenna side of the radio. It is used to
connect accessories to the radio.
NOTICE: To prevent damage to the connector, shield it with the connector cover when not in
use.
Procedure:
1
To remove the accessory connector cover, rotate the thumbscrew counterclockwise until it
disengages from the radio.
NOTICE: If the thumbscrew is too tight, use an Allen wrench at to loosen it first.
A
B
C
2 Rotate and lift the connector cover to disengage it from the radio.
3 To attach the accessory connector cover, insert the hooked end
of the cover into the slot
above the connector.
4 Press the top of the cover downward to seat it in the slot.
5 Once in place, tighten by rotating the thumbscrew clockwise by hand.
MN006727A01-AA
Preparing Your Radio for Use
18