User Manual

Preparing Your Radio for
Use
This section provides simple instructions to prepare your
radio for use.
Charging the Battery
WARNING:
To avoid a possible explosion:
• Do not replace the battery in any area labeled
hazardous atmosphere.
• Do not discard batteries in a fire.
The Motorola Solutions-approved battery shipped with your
radio is uncharged. Prior to using a new battery, charge it
for a minimum of 16 hours to ensure optimum capacity and
performance. For a list of Motorola Solutions-authorized
batteries and chargers available for use with your radio,
see Accessories on page 183.
NOTICE:
When charging a battery attached to a radio, turn
the radio off to ensure a full charge.
To charge the battery, place the battery (with or
without the radio) in a Motorola Solutions-approved
charger.
The LED on the charger indicates the charging
progress; see the Charger User Guide.
Attaching the Battery
You can view the status of the battery if the radio is using
an IMPRES battery. See IMPRES Battery Annunciator on
page 174 for more information.
NOTICE:
Radio supports revision B and above for
PMNN4491 battery. Check with your dealer or
system administrator for more information.
1 Slide the battery into the radio frame until the latch
which is at the bottom of the radio clicks into place.
English
Send Feedback 29