User Manual

• The display shows Emergency on the current
zone and channel. A tone sounds and the LED
blinks red momentarily.
• A tone sounds to indicate the selected channel
does not support emergency and rejects to
launch emergency mode.
2 Hold the radio vertically 1 to 2 inches (2.5 to 5.0 cm)
from your mouth.
3 The microphone remains active for the hot mic time
specified in the radio's codeplug programming.
4 To exit Emergency Call, press and hold the
preprogrammed Emergency button.
Sending an Emergency Alarm with
Emergency Call
This feature gives your radio priority access on a channel
for conventional system, and to a talkgroup for trunking
system.
1 Press the preprogrammed Emergency button.
If successful, the display shows Emergency on the
current zone and channel. You hear a short,
medium-pitched tone and the LED blinks red
momentarily.
The radio exits Emergency Alarm and enters the
Emergency Call state when one of the following
scenarios occur:
• You receive the dispatcher acknowledgment. The
display shows Ack received.
• You receive no acknowledgement. The display
shows No acknowledge.
• You press the PTT button while in the Emergency
Alarm mode.
If unsuccessful, you hear the radio sounds a short
low-pitched tone to indicate the selected channel
English
96 Send Feedback