User Manual

Entering the Geofence Area
The Voice Announcement and TMS display in this feature
are optional. They must be configured to enable you to
hear and see these indicators.
When the radio enters a Geofence area, the radio
immediately sends a message ACK back to the system.
The radio searches the current zone for the channel with
same talkgroup assigned as the Dynamic Talkgroup and
also with same system ID of current trunk system. Once
matched, the radio display shows the first matched and
connected channel alias.
If there is no channel with matching Talkgroup ID and trunk
system ID, the radio display shows the channel alias of
<DYNAMIC talkgroup>.
Once the radio is connected, you hear a dynamic regroup
tone, the radio display shows <DYNAMIC channel> with
temporary green color intelligent backlight and you hear a
Voice Announcement.
NOTICE:
When the radio loses the GPS signal, the GPS icon
blinks and the radio sounds two high-pitched tones
repetitively to indicate that the GPS has failed to
operate. The radio display shows the red intelligent
light.
If the first matched channel is not configured with
Voice Announcement, no Voice Announcement is
played.
The system sends a message to your radio. The radio
display shows a direct text message content without any
user operation. This message indicates you are currently
present in a Geofence area. This TMS remains open on the
display until user presses exit/home to exit this screen.
NOTICE:
If there is another incoming text message before
you exit the previous message, the message screen
is refreshed to show the latest message.
English
Send Feedback 139