User Manual

Turning Scan On or Off
Perform one of the following actions:
•
Press the preprogrammed Scan button to
toggle Scan On or Scan Off to initiate or stop
scan.
•
Turn the preprogrammed Scan switch to the
Scan on or Scan off position to initiate or stop
scan.
•
or to Scan and press the Menu Select button
directly below Scan.
If the scan is enabled, the display shows Scan on
and the scan status icon.
If the scan is disabled, the display shows Scan Off.
The radio returns to the Home screen.
Making a Dynamic Priority Change (Conventional Scan
Only)
While the radio is scanning, the dynamic priority
change feature allows you to temporarily change any
channel in a scan list (except for the Priority-One
channel) to the Priority-Two channel.
This change remains in effect until scan is turned off.
Scan then reverts to the preprogrammed (original)
setting.
Making a Dynamic Priority Change via the
preprogrammed Dynamic Priority button:
a) When the radio locks onto the channel
designated as the new Priority-Two channel,
press the preprogrammed Dynamic Priority
button.
The radio continues scanning the remaining
channels in the list.
Deleting a Nuisance Channel
If a channel continually generates unwanted calls or
noise (termed a “nuisance” channel), you can
temporarily remove the unwanted channel from the
scan list.
This capability does not apply to priority channels or
the designated transmit channel.
When the radio is locked onto the channel to be
deleted, perform one of the following actions:
•
Press the preprogrammed Nuisance Delete
button.
Advanced Features
82
English