User Manual

assigned to the desired network. These network-to-
zone assignments are configured by your dealer
through radio programming.
Selecting a Call Type
Use the 4–Way Navigation Disc to select a call type.
This can be a Group Call, Multi-group Call, Site All
Call or Private Call, depending on how your radio is
programmed. If you navigate with the 4–Way
Navigation Disc to a different Call Type this causes
the radio to re-register with the Connect Plus site.
The radio registers with the Registration Group ID
that has been programmed for the new
call type.
If you select a position that has no call type assigned
to it, your radio sounds a continuous tone and the
display shows Unprogrammed. Your radio does not
operate when selected to an unprogrammed channel,
use the 4–Way Navigation Disc to select a
programmed channel instead.
Once the required zone is displayed (if you have
multiple zones in your radio), use the 4–Way
Navigation Disc
to select the call type.
Receiving and Responding to a Radio Call
Once the channel, subscriber ID or call type is
displayed, you can proceed to receive and respond to
calls.
The LED lights up solid green while the radio is
transmitting and blinks green when the radio is
receiving.
Note:
The LED lights up solid green while the radio
is transmitting and blinks green rapidly
when
the radio is receiving a privacy-enabled call.
To unscramble a privacy-enabled call, your
radio must have the same Privacy Key, OR
the same Key Value and Key ID (programmed
by your dealer), as the transmitting radio (the
radio you are receiving the call from).
Note:
See Privacy on page 237 for more
information.
Making and Receiving Calls in Connect Plus Mode
185
English