User Manual
Table Of Contents
- Contents
- Declaration of Conformity
- Important Safety Information
- Software Version
- Computer Software Copyrights
- Handling Precautions
- Getting Started
- Preparing Your Radio for Use
- Identifying Radio Controls
- Identifying Status Indicators
- Making and Receiving Calls
- Advanced Features
- Radio Check
- Scan Lists
- Scan
- Vote Scan
- Contact Settings
- Call Indicator Settings
- Call Log Features
- Call Alert Operation
- Emergency Operation
- Privacy
- Security
- Lone Worker
- Password Lock Features
- Notification List
- Auto-Range Transponder System (ARTS)
- Over-the-Air-Programming (OTAP)
- Wi-Fi Operation
- Utilities
- Setting the Squelch Level
- Setting the Power Level
- Adjusting the Display Brightness
- Turning the Voice Operating Transmission (VOX) Feature On or Off
- Setting the Display Backlight Timer
- Turning the Radio Tones/Alerts On or Off
- Turning the Power Up Alert Tone On or Off
- Setting the Tone Alert Volume Offset Level
- Turning the Talk Permit Tone On or Off
- Language
- Turning the LED Indicator On or Off
- Turning the Introduction Screen On or Off
- Turning the Voice Announcement On or Off
- Call Forwarding
- Menu Timer
- Analog Mic AGC (Mic AGC-A)
- Digital Mic AGC (Mic AGC-D)
- Intelligent Audio
- Turning the Acoustic Feedback Suppressor Feature On or Off
- Accessing General Radio Information
- Checking the RSSI Values
- Front Panel Configuration (FPC)
- Authorized Accessories List
- Batteries and Chargers Warranty
- Limited Warranty
- Blank Page
b)
Press or to WiFi and press to
select.
c)
Press or to Turn On and press
to select.
The radio displays Turning On WiFi.
Connecting to a Network Access Point
Note:
This feature is applicable to XPR 3500e only.
When you turn on Wi-Fi
®
, the radio scans and
connects to a network access point.
Viewing Details of Network Access Points
Note:
This feature is applicable to XPR 3500e only.
Perform the following actions to view details of
network access points.
1
Press
to access the menu.
2
Press or to WiFi and press to
select.
3
Press or to a network access point
and press to select.
4
Press or to view Network SSID,
Security Mode, IP Address, and MAC Address.
For a non-connected network access point, only
the Service Set Identifier (SSID) and Security
Mode are displayed.
Utilities
Setting the Squelch Level
You can adjust your radio's squelch level to filter out
unwanted calls with low signal strength or channels
that have a higher than normal background noise.
Normal is the default. Tight filters out (unwanted)
calls and/or background noise; however, calls from
remote locations may also be filtered out.
Note:
This feature is not applicable in Citizens Band
channels that are in the same frequency.
Advanced Features
79
English