User Manual
Table Of Contents
- Contents
- Declaration of Conformity
- Important Safety Information
- Software Version
- Computer Software Copyrights
- Handling Precautions
- Getting Started
- Preparing Your Radio for Use
- Identifying Radio Controls
- Identifying Status Indicators
- Making and Receiving Calls
- Advanced Features
- Radio Check
- Scan Lists
- Scan
- Vote Scan
- Contact Settings
- Call Indicator Settings
- Call Log Features
- Call Alert Operation
- Emergency Operation
- Privacy
- Security
- Lone Worker
- Password Lock Features
- Notification List
- Auto-Range Transponder System (ARTS)
- Over-the-Air-Programming (OTAP)
- Wi-Fi Operation
- Utilities
- Setting the Squelch Level
- Setting the Power Level
- Adjusting the Display Brightness
- Turning the Voice Operating Transmission (VOX) Feature On or Off
- Setting the Display Backlight Timer
- Turning the Radio Tones/Alerts On or Off
- Turning the Power Up Alert Tone On or Off
- Setting the Tone Alert Volume Offset Level
- Turning the Talk Permit Tone On or Off
- Language
- Turning the LED Indicator On or Off
- Turning the Introduction Screen On or Off
- Turning the Voice Announcement On or Off
- Call Forwarding
- Menu Timer
- Analog Mic AGC (Mic AGC-A)
- Digital Mic AGC (Mic AGC-D)
- Intelligent Audio
- Turning the Acoustic Feedback Suppressor Feature On or Off
- Accessing General Radio Information
- Checking the RSSI Values
- Front Panel Configuration (FPC)
- Authorized Accessories List
- Batteries and Chargers Warranty
- Limited Warranty
- Blank Page
until the hot mic duration expires. While
transmitting, the LED lights up solid green and the
Emergency icon appears on the display.
3 The radio automatically stops transmitting when
the cycling duration between hot mic and receiving
calls expires, if Emergency Cycle Mode is
enabled.
4 Once the hot mic duration expires, the radio
automatically stops transmitting. The LED blinks
red and the radio remains in Emergency mode. To
transmit again, press the PTT button.
Reinitiating an Emergency Mode
Note:
This feature is only applicable to the radio
sending the Emergency Alarm.
There are two instances where this can happen:
• You change the channel while the radio is in
Emergency mode. This exits the Emergency
mode. If Emergency Alarm is enabled on this new
channel, the radio reinitiates Emergency.
• You press the programmed Emergency On
button during an Emergency initiation/transmission
state. This causes the radio to exit this state, and
to reinitiate Emergency.
Exiting Emergency Mode After Sending the Emergency
Alarm
Your radio exits Emergency mode when one of the
following occurs:
• Emergency Alarm acknowledgement is received
(for Emergency Alarm only).
• All retries to send the alarm have been exhausted.
• The Emergency Off button is pressed.
Note:
If your radio is powered off, it exits the
Emergency mode. The radio will not reinitiate
the Emergency mode automatically when it is
turned on again.
Privacy
If enabled, this feature helps to prevent
eavesdropping by unauthorized users on a channel
by the use of a software-based scrambling solution.
The signaling and user identification portions of a
transmission are not scrambled.
Advanced Features
68
English