User Manual
Table Of Contents
- Contents
- Declaration of Conformity
- Important Safety Information
- Software Version
- Computer Software Copyrights
- Handling Precautions
- Getting Started
- Preparing Your Radio for Use
- Identifying Radio Controls
- Identifying Status Indicators
- Making and Receiving Calls
- Advanced Features
- Radio Check
- Scan Lists
- Scan
- Vote Scan
- Contact Settings
- Call Indicator Settings
- Call Log Features
- Call Alert Operation
- Emergency Operation
- Privacy
- Security
- Lone Worker
- Password Lock Features
- Notification List
- Auto-Range Transponder System (ARTS)
- Over-the-Air-Programming (OTAP)
- Wi-Fi Operation
- Utilities
- Setting the Squelch Level
- Setting the Power Level
- Adjusting the Display Brightness
- Turning the Voice Operating Transmission (VOX) Feature On or Off
- Setting the Display Backlight Timer
- Turning the Radio Tones/Alerts On or Off
- Turning the Power Up Alert Tone On or Off
- Setting the Tone Alert Volume Offset Level
- Turning the Talk Permit Tone On or Off
- Language
- Turning the LED Indicator On or Off
- Turning the Introduction Screen On or Off
- Turning the Voice Announcement On or Off
- Call Forwarding
- Menu Timer
- Analog Mic AGC (Mic AGC-A)
- Digital Mic AGC (Mic AGC-D)
- Intelligent Audio
- Turning the Acoustic Feedback Suppressor Feature On or Off
- Accessing General Radio Information
- Checking the RSSI Values
- Front Panel Configuration (FPC)
- Authorized Accessories List
- Batteries and Chargers Warranty
- Limited Warranty
- Blank Page
connected. Additionally, some settings can also be
configured via OTAP.
While undergoing OTAP, the LED blinks green
.
Note:
When the radio is receiving high volume data,
the High Volume Data icon appears and
channel is busy. A PTT button press at this
time may cause a negative tone to sound.
Once the programming is complete, depending on
your radio’s configuration:
•
A tone sounds, the display shows Updating
Restarting, and your radio restarts (powers off
and on again).
•
Select between Restart Now or Postpone.
Selecting Postpone allows your radio to return to
the previous display, with an OTAP Timer icon
visible, for a period of time before the automatic
restart occurs.
Upon power up after the automatic restart occurs, the
display shows Sw Update Completed if the OTAP
update is successful or Sw Update Failed if the
OTAP update is unsuccessful.
See Software Update on page 93
for your updated
software version.
Wi-Fi Operation
Wi-Fi
®
is a registered trademark of Wi-Fi Alliance
®
.
Note:
This feature is applicable to XPR 3500e
only.
This feature allows you to setup and connect to a Wi-
Fi
®
network. Wi-Fi supports updates of radio
firmware, codeplug, and resources such as language
packs and voice announcement.
Turning Wi-Fi On or Off
Note:
This feature is applicable to XPR 3500e
only.
The programmed Wi-Fi On or Off button is
assigned via CPS. Check with your dealer or
system administrator to determine how your
radio has been programmed.
You can turn on or turn off Wi-Fi
®
by performing one
of the following actions.
Advanced Features
77
English