User Manual
Table Of Contents
- Contents
- Declaration of Conformity
- Important Safety Information
- Software Version
- Computer Software Copyrights
- Handling Precautions
- Getting Started
- Preparing Your Radio for Use
- Identifying Radio Controls
- Identifying Status Indicators
- Making and Receiving Calls
- Advanced Features
- Radio Check
- Scan Lists
- Scan
- Vote Scan
- Contact Settings
- Call Indicator Settings
- Call Log Features
- Call Alert Operation
- Emergency Operation
- Privacy
- Security
- Lone Worker
- Password Lock Features
- Notification List
- Auto-Range Transponder System (ARTS)
- Over-the-Air-Programming (OTAP)
- Wi-Fi Operation
- Utilities
- Setting the Squelch Level
- Setting the Power Level
- Adjusting the Display Brightness
- Turning the Voice Operating Transmission (VOX) Feature On or Off
- Setting the Display Backlight Timer
- Turning the Radio Tones/Alerts On or Off
- Turning the Power Up Alert Tone On or Off
- Setting the Tone Alert Volume Offset Level
- Turning the Talk Permit Tone On or Off
- Language
- Turning the LED Indicator On or Off
- Turning the Introduction Screen On or Off
- Turning the Voice Announcement On or Off
- Call Forwarding
- Menu Timer
- Analog Mic AGC (Mic AGC-A)
- Digital Mic AGC (Mic AGC-D)
- Intelligent Audio
- Turning the Acoustic Feedback Suppressor Feature On or Off
- Accessing General Radio Information
- Checking the RSSI Values
- Front Panel Configuration (FPC)
- Authorized Accessories List
- Batteries and Chargers Warranty
- Limited Warranty
- Blank Page
The display shows Call Ended.
Stopping a Radio Call
This feature allows you to stop an ongoing Group or
Private Call to free the channel for transmission. For
example, when a radio experiences a “stuck
microphone” condition where the PTT button is
inadvertently pressed by the user.
Your radio must be programmed to allow you to use
this feature.
1 Press the programmed Transmit Interrupt
Remote Dekey button, while on the relevant
channel.
The display shows Remote Dekey.
2 Wait for acknowledgement.
If successful, the radio sounds a positive indicator
tone and the display shows Remote Dekey
Success, indicating that the channel is now free.
If unsuccessful, the radio sounds a negative
indicator tone and the display shows Remote
Dekey Failed.
On the interrupted radio, the remote radio’s display
shows Call Interrupted, and the radio sounds a
negative indicator tone until the PTT button is
released.
Talkaround
You can continue to communicate when your
repeater is not operating, or when your radio is out of
the repeater’s range but within talking range of other
radios.
This is called “talkaround”.
Note:
This feature is not applicable in Capacity Plus
and Linked Capacity Plus.
The Talkaround setting is retained even after
powering down.
You can toggle between talkaround and repeater
modes by pressing the programmed Repeater/
Talkaround button or using the radio menu as
described next.
Note:
This feature is not applicable in Citizens Band
channels that are in the same frequency.
Making and Receiving Calls
45
English