User Manual
Table Of Contents
- Contents
- Declaration of Conformity
- Important Safety Information
- Software Version
- Computer Software Copyrights
- Handling Precautions
- Getting Started
- Preparing Your Radio for Use
- Identifying Radio Controls
- Identifying Status Indicators
- Making and Receiving Calls
- Advanced Features
- Radio Check
- Scan Lists
- Scan
- Vote Scan
- Contact Settings
- Call Indicator Settings
- Call Log Features
- Call Alert Operation
- Emergency Operation
- Privacy
- Security
- Lone Worker
- Password Lock Features
- Notification List
- Auto-Range Transponder System (ARTS)
- Over-the-Air-Programming (OTAP)
- Wi-Fi Operation
- Utilities
- Setting the Squelch Level
- Setting the Power Level
- Adjusting the Display Brightness
- Turning the Voice Operating Transmission (VOX) Feature On or Off
- Setting the Display Backlight Timer
- Turning the Radio Tones/Alerts On or Off
- Turning the Power Up Alert Tone On or Off
- Setting the Tone Alert Volume Offset Level
- Turning the Talk Permit Tone On or Off
- Language
- Turning the LED Indicator On or Off
- Turning the Introduction Screen On or Off
- Turning the Voice Announcement On or Off
- Call Forwarding
- Menu Timer
- Analog Mic AGC (Mic AGC-A)
- Digital Mic AGC (Mic AGC-D)
- Intelligent Audio
- Turning the Acoustic Feedback Suppressor Feature On or Off
- Accessing General Radio Information
- Checking the RSSI Values
- Front Panel Configuration (FPC)
- Authorized Accessories List
- Batteries and Chargers Warranty
- Limited Warranty
- Blank Page
dealer), you will hear a short alert tone the moment
the target radio (the radio that is receiving your call)
releases the PTT button, indicating the channel is
free for you to respond.
You will also hear a continuous talk prohibit tone, if
your call is interrupted, indicating that you should
release the PTT button, for example when the radio
receives an Emergency Call.
Switching Between Conventional Analog and
Digital Mode
Each channel in your radio can be configured as a
conventional analog or conventional digital channel.
Use the Channel Selector Knob ( ) to switch
between an analog or a digital channel.
A
When switching from digital to analog mode, certain
features are unavailable.
Icons for the digital features
(such as Messages) reflect this change by appearing
‘grayed out’. Disabled features are hidden in the
menu.
Your radio also has features available in both analog
and digital mode. However, the minor differences in
the way each feature works does not affect the
performance of your radio.
Note:
Your radio also switches between digital and
analog modes during a dual mode scan (see
Scan on page 51).
Identifying Radio Controls
24
English