User Manual

Table Of Contents
Making a Phone Call with the Programmable Phone
Button
1 Press the programmed Phone button to enter into
the Phone Entry list.
2
or to the required subscriber alias or ID,
and press to select.
If the access code was not preconfigured in the
Contacts list, the display shows Access Code:.
Enter the access code and press the
button
to proceed.
The LED lights up solid green. The Phone Call
icon appears in the top right corner. The first text
line shows the subscriber alias. The second text
line displays the call status.
If the call-setup is successful, the DTMF tone
sounds. You hear the dialing tone of the telephone
user. The first text line shows the subscriber alias.
The Phone Call icon remains in the top right
corner. The second text line displays the call
status.
If call-setup is unsuccessful, a tone sounds and
the display shows Phone Call Failed
. Your
radio returns to the Access Code input screen. If
the access code was preconfigured in the
Contacts list, the radio returns to the screen you
were on prior to initiating the call.
3 Hold the radio vertically 1 to 2 inches (2.5 to 5.0
cm) from your mouth.
4 Press the PTT button to talk and release it to
listen.
5 To enter extra digits, if requested by the Phone
Call, do one of the following.
Press any keypad key to begin the input of the
extra digits. The first line of the display shows
Extra Digits:. The second line of the display
shows a blinking cursor. Enter the extra digits
and press the button to proceed. The
DTMF tone sounds and the radio returns to the
previous screen.
Press One Touch Access
button. The DTMF
tone sounds. If the entry for the One Touch
Making and Receiving Calls in Non-Connect Plus Mode
64
English