User Manual

If you initiate an Emergency Alert by pressing the
programmed Emergency button, your radio
automatically exits Emergency mode after receiving a
response from the Connect Plus system.
If you initiate an Emergency call by pressing the
programmed Emergency button, your radio will be
assigned a channel automatically when one becomes
available. Once your radio has transmitted a
message indicating the emergency, you cannot
cancel your Emergency call. However, if you pressed
the button by accident or the emergency no longer
exists, you may wish to say this over the assigned
channel. When you release the PTT button, the
Emergency call is discontinued after the Emergency
Call Hang Time expires.
If your radio was configured for Emergency with Voice
to Follow, use the “hot mic” period to explain your
error, then press and release the PTT button to
discontinue the transmission. The Emergency call is
discontinued after the Emergency Call Hang Time
expires.
Man Down Alarms
Note:
This feature is applicable to XPR 7550e/XPR
7580e only.
Man Down Alarms are not supported when
operating in Fallback mode. For more
information see the Auto Fallback
on page
212.
This section describes the Connect Plus Man Down
Feature. This is a purchasable feature that may or
may not apply to your radio.
Your Connect Plus portable radio can be enabled and
programmed for one or more of the Man Down
Alarms. Your dealer or radio system administrator can
tell you whether or not this applies to your radio and
which specific Man Down Alarms have been enabled
and programmed.
If your radio has been programmed for one or more of
the following Man Down Alarms, it is important for you
to understand how the Alarm works, what indication
(tones) your radio provides, and the action you should
take.
Advanced Features in Connect Plus Mode
238
English