User Manual

proceed. The DTMF tone sounds and
the radio returns to the previous screen.
If the call ends while you are entering
the extra digits requested by the Phone
Call, your radio returns to the screen
you were on prior to initiating the call.
• Press One Touch Access button.
Note:
The DTMF tone sounds.
If the entry for the One Touch Access
button is empty, a negative indicator
tone sounds.
During the call, when you press One Touch
Access button with the deaccess code
preconfigured or enter the deaccess code as the
input for extra digits, your radio attempts to end
the call.
During channel access and access/deaccess code
or extra digits transmission, your radio responds to
On/Off/Volume Control Knob and Channel
Selector Knob only. A tone sounds for every
invalid input.
8
Press to end the call.
9 If deaccess code was not preconfigured in the
Contacts list, the first line of the display shows De-
Access Code:. The second line of the display
shows a blinking cursor. Enter the deaccess code
and press to proceed.
The deaccess code cannot be more than 10
characters.
The DTMF tone sounds and the display shows
Ending Phone Call.
If successful, a tone sounds and the display shows
Phone Call Ended. Your radio returns to the Call
Phone screen.
If unsuccessful, your radio returns to the Phone
Call screen. Repeat Steps 8 and 9 or wait for the
telephone user to end the call.
When the telephone user ends the call, a tone
sounds and the display shows Phone Call
Ended
.
Advanced Features in Non-Connect Plus Mode
87
English