User Manual

4
or to Call Phone and press to
select.
5 If the access code was not preconfigured in the
Contacts list, the first line of the display shows
Access Code: . The second line of the display
shows a blinking cursor. Enter the access code
and press to proceed.
During channel access, press to dismiss the
call attempt and a negative indicator tone sounds.
Your radio returns to the Call Phone screen.
The access code cannot be more than 10
characters.
The first line of the display shows Calling. The
second line of the display shows the subscriber
alias or ID, and the Phone Call icon.
If successful, the DTMF tone sounds. You hear
the dialing tone of the telephone user. The first line
of the display shows the subscriber alias or ID,
and the RSSI icon. The second line of the display
shows Phone Call and the Phone Call icon.
If unsuccessful, a tone sounds and the display
shows Phone Call Failed. Your radio returns to
the Access Code input screen. If the access code
was preconfigured in the Contacts list, the radio
returns to the screen you were on prior to initiating
the call.
6 Hold the radio vertically 1 to 2 inches (2.5 to 5.0
cm) from your mouth.
7 Do one of the following:
• Press the PTT button to talk and release it to
listen.
Note:
The RSSI icon disappears during
transmission.
To enter extra digits, if requested by the
Phone Call, press any keypad key to
begin the input of extra digits. The first
line of the display shows Extra
Digits: . The second line of the
display shows a blinking cursor. Enter
the extra digits and press to
Advanced Features in Non-Connect Plus Mode
86
English