User Manual

Table Of Contents

Access button is empty, a negative indicator

tone sounds.

Press to end the call.

If deaccess code was not preconfigured in the

Contacts list, the first line of the display shows De-

Access Code:. The second line of the display

shows a blinking cursor. Enter the deaccess code

and press the button to proceed. The radio

returns to the previous screen.

The DTMF tone sounds and the display shows

Ending Phone Call.

If the end-call-setup is successful, a tone sounds

and the display shows Call Ended

If the end-call-setup is unsuccessful, your radio

returns to the Phone Call screen. Repeat Steps 4

and 6 or wait for the telephone user to end the

call.

When you press PTT button while in the Phone

Contacts screen, a tone sounds and the display

shows Press OK to Place Phone Call.

When the telephone user ends the call, a tone

sounds

and the display shows Phone Call

Ended

If the call ends while you are entering the extra

digits requested by the Phone Call, your radio

returns to the screen you were on prior to initiating

the call.

Note:

During channel access, press to

dismiss the call attempt and a tone sounds.

During the call, when you press One

Touch Access button with the deaccess

code preconfigured or enter the deaccess

code as the input for extra digits, your radio

attempts to end the call.

Note:

The access or deaccess code cannot be

more than 10 characters.

Making and Receiving Calls in Non-Connect Plus Mode

English