User Manual
Table Of Contents
- Contents
- Declaration of Conformity
- Important Safety Information
- Software Version
- Computer Software Copyrights
- Handling Precautions
- Getting Started
- Preparing Your Radio for Use
- Identifying Radio Controls
- Non-Connect Plus Operations
- Additional Radio Controls in Non-Connect Plus Mode
- Making and Receiving Calls in Non-Connect Plus Mode
- Advanced Features in Non-Connect Plus Mode
- Scan Lists
- Scan
- Vote Scan
- Call Indicator Settings
- Call Alert Operation
- Emergency Operation
- Man Down
- Text Message Features
- Privacy
- Multi-Site Controls
- Lone Worker
- Password Lock Features
- Bluetooth Operation
- Auto-Range Transponder System (ARTS)
- Over-the-Air-Programming (OTAP)
- Wi-Fi Operation
- Utilities
- Setting the Power Level
- Turning the Option Board Feature(s) On or Off
- Turning the Voice Operating Transmission (VOX) Feature On or Off
- Turning the Radio Tones/Alerts On or Off
- Checking the Battery Strength
- Turning the Voice Announcement On or Off
- Setting the Text-to-Speech Feature
- Switching Audio Route between Internal Radio Speaker and Wired Accessory
- Intelligent Audio
- Turning the Acoustic Feedback Suppressor Feature On or Off
- Turning GPS/GNSS On or Off
- Flexible Receive List
- Connect Plus Operations
- Additional Radio Controls in Connect Plus Mode
- Making and Receiving Calls in Connect Plus Mode
- Advanced Features in Connect Plus Mode
- Accessories
- Maritime Radio Use in the VHF Frequency Range
- Batteries and Chargers Warranty
- Limited Warranty
- Blank Page
When using the programmable button to toggle the
Man Down Alarms Off, your radio plays a tone that
falls in pitch.
In order to hear the tones described above when
turning the Man Down Alarms On and Off, the
MOTOTRBO radio and Connect Plus Option Board
must both be enabled for keypad tones.
Resetting the Man Down Alarms
Note:
This feature is applicable to XPR 7350e/XPR
7380e
only.
If your radio has been programmed with a Man Down
Alarms Reset button, it is possible to reset the Man
Down Alarms without turning them On or Off. This
stops any Man Down Alert Tone that is currently
playing, and it also resets the Alarm timers. However,
it is still necessary to correct the movement violation
by taking the appropriate corrective action described
in the Man Down Alarms section. If the movement
violation is not corrected within a period of time, the
Alert Tone starts playing again.
Beacon Feature
This section describes the Beacon feature. The
Beacon feature is part of Connect Plus Man Down, a
purchasable feature. Your dealer or Radio System
Administrator can tell you if the Beacon feature
applies to your radio.
If your radio has been enabled and programmed for
one or more of the Man Down Alarms, it can also be
enabled for the Beacon feature.
If your radio automatically starts an Emergency Call
or Emergency Alert due to one of the Man Down
Alarms, and if your radio is also enabled for the
Beacon feature, the radio starts to periodically emit a
high pitched tone approximately once every ten
seconds. The interval can vary depending on whether
you are talking on your radio. The purpose of the
Beacon tone is to help searchers locate you. If your
radio has also been enabled for the “Visual Beacon”,
the radio’s backlight comes on for a few seconds
every time the Beacon tone plays.
You can stop your radio from playing the Beacon tone
by using a programmable button, if your radio has
been configured in this manner. This is discussed in
the next two sections. If your radio does not have the
Advanced Features in Connect Plus Mode
90
English