User Manual
Table Of Contents
- Contents
- Declaration of Conformity
- Important Safety Information
- Software Version
- Computer Software Copyrights
- Handling Precautions
- Getting Started
- Preparing Your Radio for Use
- Identifying Radio Controls
- Non-Connect Plus Operations
- Additional Radio Controls in Non-Connect Plus Mode
- Making and Receiving Calls in Non-Connect Plus Mode
- Advanced Features in Non-Connect Plus Mode
- Scan Lists
- Scan
- Vote Scan
- Call Indicator Settings
- Call Alert Operation
- Emergency Operation
- Man Down
- Text Message Features
- Privacy
- Multi-Site Controls
- Lone Worker
- Password Lock Features
- Bluetooth Operation
- Auto-Range Transponder System (ARTS)
- Over-the-Air-Programming (OTAP)
- Wi-Fi Operation
- Utilities
- Setting the Power Level
- Turning the Option Board Feature(s) On or Off
- Turning the Voice Operating Transmission (VOX) Feature On or Off
- Turning the Radio Tones/Alerts On or Off
- Checking the Battery Strength
- Turning the Voice Announcement On or Off
- Setting the Text-to-Speech Feature
- Switching Audio Route between Internal Radio Speaker and Wired Accessory
- Intelligent Audio
- Turning the Acoustic Feedback Suppressor Feature On or Off
- Turning GPS/GNSS On or Off
- Flexible Receive List
- Connect Plus Operations
- Additional Radio Controls in Connect Plus Mode
- Making and Receiving Calls in Connect Plus Mode
- Advanced Features in Connect Plus Mode
- Accessories
- Maritime Radio Use in the VHF Frequency Range
- Batteries and Chargers Warranty
- Limited Warranty
- Blank Page
discontinue the transmission. The Emergency call is
discontinued after the Emergency Call Hang Time
expires.
Man Down Alarms
Note:
This feature is applicable to XPR 7350e/XPR
7380e only.
Man Down Alarms are not supported when
operating in Fallback mode. For more
information see the
Auto Fallback on page 78.
This section describes the Connect Plus Man Down
Feature. This is a purchasable feature that may or
may not apply to your radio.
Your Connect Plus portable radio can be enabled and
programmed for one or more of the Man Down
Alarms. Your dealer or radio system administrator can
tell you whether or not this applies to your radio and
which specific Man Down Alarms have been enabled
and programmed.
If your radio has been programmed for one or more of
the following Man Down Alarms, it is important for you
to understand how the Alarm works, what indication
(tones) your radio provides, and the action you should
take.
The purpose of the Man Down Alarms is to alert
others when you might be in danger. This is
accomplished by programming your radio to detect a
certain angle of tilt, lack of movement, or movement,
depending on which Man Down Alarm(s) is/are
enabled. If your radio detects a disallowed movement
type, and if the condition is not corrected in a certain
period of time, the radio starts to play an Alert Tone (if
so programmed). At this point you should immediately
take one or more of the corrective actions discussed
below, depending on which Man Down Alarm(s) has/
have been enabled for your radio. If you do not take
corrective action within a certain period of time, your
radio automatically starts an Emergency (either an
Emergency Call or Emergency Alert).
• Tilt Alarm – When your radio is tilted at or beyond
a specified angle for a period of time, it plays an
Alert Tone (if so programmed). To prevent the
radio from automatically starting an Emergency
Call or Emergency Alert, restore the radio to the
vertical position immediately.
• Anti-Movement Alarm – When your radio is
motionless for a period of time, it plays an Alert
Advanced Features in Connect Plus Mode
88
English