User Manual

You can start and stop scanning by pressing the
programmed Scan button.
• A tone sounds indicating that Scan has been
turned on or off.
•
When Scan is enabled, the tone’s pitch increases.
• When Scan is disabled, the tone’s pitch
decreases.
Responding to a Transmission During a Scan
During scanning, your radio stops on a group where
activity is detected. The radio continuously listens for
any member in the scan list when idle on the control
channel.
1 Hold the radio vertically 1 to 2 inches (2.5 to 5.0
cm) from your mouth.
2 Press the PTT button during hang time.
The LED lights up solid green.
3 Wait for the Talk Permit Tone to finish (if enabled),
and speak clearly into the microphone.
4 Release the PTT button to listen.
If you do not respond within the hang time, the
radio returns to scanning other groups.
Turning Scan On or Off
Note:
This procedure turns the Scan feature On or
Off for all zones with the same Network ID as
your currently selected zone.
When Scan is on and you are not participating in a
call, the LED blinks green and yellow.
The procedure for turning Scan on or off depends on
how your radio is programmed. If programmed with a
Scan On/Off button, use the button to toggle the
feature on or off.
• A tone sounds indicating that Scan has been
turned on or off.
•
When Scan is enabled, the tone’s pitch increases.
• When Scan is disabled, the tone’s pitch
decreases.
Understanding Scan Operation
Note:
If you scan into a call for a group that is not
assigned to a channel position in the currently
selected zone and you miss the call’s Hang
Time, switch to the proper zone and then
Advanced Features in Connect Plus Mode
80
English